In Florida I've always had issues with the Rainbird system there. One of the neighbors got a deal here and had to redo all of his system including the sprinkler lines cuz they were installed too close to the surface.Īll in all though sprinkler parts in general are inexpensive. The endeavor / installation of the sprinkler tubing and heads really isn't a DIY. Weather data is from Cumulus and the internet. I then migrated from the Homeseer server running mcsSprinklers to mcsSprinklers for Linux running it on a Seagate Dockstar with ArchLinux on it. A couple of years ago I did lose the Rain8nets due to a lightning strike. I removed it and installed two Rain8nets about a week after it was installed and connected to mcsSprinklers. The most inexpensive piece of the system was the controller which at the time was a Rainbird ESP. I have replaced maybe 3 heads out of about 42 heads. Its been now almost 10 years and the manifold and solenoids are doing fine. That said when it was being installed I had the installers run extra tubing from the house to the periferals of the property. I had my sprinkler system initially installed by a Rainbird dealer so everything was originally Rainbird. I'm not affiliated with this site in any way, just a happy customer. This version will be free, though if I end up making a full blown irrigation control system out of it there may be a charge for future releases. If there's any interest I'll post the plugin either on the forum or possibly in the updater. Polls valve status every 60 seconds and optionally after every on/off operation.If HomeSeer crashes while watering, the OpenSprinkler unit will shut the valve off after the specified time Every time a valve is turned on it will set a max allowable watering time.Creates one device that displays overall status (Idle, Watering, Not Responding).Supports OpenSprinkler and up to 10 expansion modules for control of up to 88 valves on one Ethernet connection.Creates one on/off device for each sprinkler valve.Minimal configuration (INI file is 10 lines long).It also uses the stock firmware, so no modification or reprogramming is required on the OpenSprinkler unit. It uses HTTP GETs to control the valves and report status. It's a pretty simple plugin with no configuration other than a few lines in an INI file. I just finished coding and testing a plugin to control the OpenSprinkler ethernet irrigation controller. It sounds like a great adventure no matter how you decide to do it! Building the interface is the key as you have described. Much like the EZfloras, its a solid device but the built in scheduling doesn't allow homeseer's integration and ease of control. Most likely there are pages with zone tests or zone on / zone off capabilities in addition to the schedule pages. There's a picture on the OpenSprinkler page that shows simple web based configuration by zone I was thinking a plugin or even a script that did PUTs and GETS that would allow a straightforward way to communicate with it. A plugin or script is needed to accomplish that. Like MCS Sprinklers, Snevl sprinklers assumes you've connected Homeseer to the valve controls via a device. eg more watering when its hotter, less when its rained, etc. You can also manipulate the schedules with events and scripts. It doesn't provide the computational / weather capabilities of MCS sprinklers, but it does make it very easy to configure multiple schedules for homeseer defined sprinkler zone devices. Snevl Sprinklers is a free scripting / aspx based sprinkler scheduling solution for homeseer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |